Thick (.5mm, 1mm, etc) cutting wheels for brass

new

« Prev
1
Next »

petermann
New Member

Posts: 1

Thick (.5mm, 1mm, etc) cutting wheels for brass Feb 17, 2021 19:25:24 GMT 1

Quote

Post by petermann on Feb 17, 2021 19:25:24 GMT 1

Using my ancient Pultra lathe, I want to cut slots of various sizes in brass using a dremel cutting wheel. I have some thin ones (less than 1mm thick) but I want to purchase a set of wheels in various cutting sizes. For example .50mm, .75mm, 1mm, 1.3mm etc and so on and I cannot find what I want online. The width of the wheels is not that important. Nor do I need the exact sizes mention above but I want a choice. Can some send me a link to a on line shop in the UK that can supply me. It must be out there but just cannot find it. Thanks. Peter

Attachments:

Shoutbox

Chrys: Any Adapter available so that my Dremel4000 can accommodate bigger drill bits? Apr 27, 2017 0:46:08 GMT 1

Gary: I have a Dremel Moto-Shop table scroll saw model 57. Not a model 57-2, but a model 57. No one seems to know anything about it. It looks just like the 57-2 and is tan instead of grey. Can someone shed some light on this? Dec 1, 2018 4:42:01 GMT 1

ukcarver045: Hi , I have just replaced the Brushes in my Dremel 3000, all straight foreword as instructed i have run at very low speed for at least 10 minuets my problem,, the unit has started to smoke

help. Sept 26, 2020 12:40:02 GMT 1

Javi: Extension bar dremel3000: I looking for an extension bar (rigid) to extend one of the sanding tools. May 25, 2023 12:45:41 GMT 1

Javi: Extension bar dremel3000: Problem is that the maximum diameter should be less than 16 mm (0.63 inches). May 25, 2023 12:48:05 GMT 1